Paper Jamned in Canon Mx922 Removed but Error Code Continues

REFERENCE

If you need to turn off the printer to remove jammed paper during printing, press the RESUME/CANCEL button to cancel print jobs before turning off the printer.

If the paper is jammed in the Paper Output Slot or the Rear Tray:

Remove the paper following the procedure below.

1. Slowly pull the paper out, either from the Rear Tray or from the Paper Output Slot, whichever is easier.

REFERENCE

  • If the paper tears and a piece remains inside the printer, open the Top Cover and remove it. Be careful not to touch the components inside the printer. After removing all paper, close the Top Cover, turn the printer off, and turn it back on.
  • If you cannot pull the paper out, turn the printer off and turn it back on. The paper may be ejected automatically.

2. Reload the paper, and press the RESUME/CANCEL button on the printer.

If you turned off the printer in step 1, all print jobs in the queue are canceled. Reprint if necessary.

REFERENCE

  • When reloading the paper, confirm that you are using the correct paper and are loading it correctly.See[ Loading Paper ].
  • A5-sized paper is suited to printing documents consisting mainly of text. We do not recommend using such paper to print documents with photos or graphics, since the printout may curl and cause paper exit jams.

If you cannot remove the paper or the paper tears inside the printer, or if the paper jam error continues after removing the paper, contact your Canon service representative.

If paper is jammed inside the printer at the transport unit:

Remove the paper following the procedure below.

1. Detach the Rear Cover.

2. Pull the paper out slowly.

NOTE

Be careful not to touch the components inside the printer.

If you cannot pull the paper out, turn the printer off and turn it back on. The paper may be ejected automatically.

3. Attach the Rear Cover.

Push the left side of the Rear Cover until it is closed completely.

If you were not able to remove the paper out in step 2:

4. Remove the Cassette.

5. Pull the paper out slowly.

6. If any paper is sticking out of the Cassette, remove the paper, align and reload the paper in the Cassette.

If you did not remove the jammed paper out in step 1 to 5 when automatic duplex printing, check the duplex transport section.

REFERENCE

When reloading the paper into the printer, confirm that you are using the correct paper and are loading it into the printer correctly.See[ Loading Paper ].

7. Insert the Cassette into the printer again, and press the RESUME/CANCEL button on the printer.

If you turned off the printer in step 2, all print jobs in queue are canceled. Reprint if necessary.

If you cannot remove the paper or if the paper tears inside the printer, or if the paper jam error continues after removing the paper, contact your Canon service representative.

If the jammed paper is not removed out when automatic duplex printing:

Remove the paper following the procedure below.

1. Turn off the printer, and unplug the power cord of the printer from the power supply.

2. Remove the Cassette.

If the paper is loaded on the Rear Tray, remove the paper from the Rear Tray and retract the Paper Support.

3. Set the printer upright with the left side down.

4. Slowly pull the jammed paper out so that the paper does not tear.

NOTE

Set the printer back to its original position immediately after removing the jammed paper.

5. Align the paper, then reload it in the Cassette.

Reload paper in the Rear Tray, if necessary.

NOTE

When reloading the paper into the printer, confirm that you are using the correct paper and are loading it into the printer correctly.See[ Loading Paper ].

6. Insert the Cassette into the printer again.

7. Plug the printer back in and turn the printer back on.

All print jobs in queue are canceled. Reprint if necessary.

If you cannot remove the paper or if the paper tears inside the printer, or if the paper jam error continues after removing the paper, contact your Canon service representative.

In other cases:

Check 1: Are there any foreign objects in the Rear Tray or around the Paper Output Slot?

Check 2: Is the Rear Cover closed completely?

Check 3: Is the paper curled?


roosbleaked.blogspot.com

Source: https://sg.canon/en/support/8200193400

0 Response to "Paper Jamned in Canon Mx922 Removed but Error Code Continues"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel